Quick Start Guide

ManualsBrandsTP-Link ManualsComputers & TabletsTP-Link - Archer AX6000 Dual-Band Wi-Fi 6 Router - Black

Choose your device type

Archer C5400X

Range Extender

Router

Archer AX6000

If your internet connection is through an Ethernet cable directly from the wall instead of through a DSL / Cable /

Satellite modem, connect the Ethernet cable to the router’s WAN port, and then follow steps 3 and 4 to complete the

hardware connection.

Connect the Hardware

Before You Start

Turn o your modem, if any, and

remove the backup battery if it has

one.

Method ONE: Via a Web Browser

The default wireless network names (SSIDs) and password are printed

on the label at the bottom of the router.

1. Connect your device to the router wirelessly

or with an Ethernet cable.

2. Launch a web browser, and enter

http://tplinkwifi.net or http://192.168.0.1 in

the address bar. Create a password to log in.

3. Follow the step-by-step instructions to

set up the internet connection and

Note: If the login window does not appear, please refer to Q1 of Need

Help? in this guide.

Verify the LED on the top is solid

on (red or blue) before moving on.

Set Up the Network

Method TWO: Via TP-Link Tether App

1. Download the Tether app.

Scan for Tether

Tether

2. Tap the button in the Tether app and

select Archer AX6000. Follow the steps

to complete the setup and connect to

the internet.

Internet

Connect the modem to

the router’s WAN port

with an Ethernet cable.

Turn on the modem, and then wait

about 2 minutes for it to restart.

Connect the power adapter to

the router and turn on the router.

Place the router horizontally

and extend the antennas to

the maximum angle.

Wireless Password/PIN:XXXXXXXX

SSID:TP-Link_XXXX

SSID:TP-Link_XXXX_5G

http://tplinkwifi.net

Let’s Get Started

Confirm Password

Password

Summary of content (2 pages)

PAGE 1
Before You Start Turn off your modem, if any, and remove the backup battery if it has one. Place the router horizontally and extend the antennas to the maximum angle. Set Up the Network Method ONE: Via a Web Browser 1. Connect your device to the router wirelessly or with an Ethernet cable. The default wireless network names (SSIDs) and password are printed on the label at the bottom of the router. Connect the Hardware Internet 1. Download the Tether app.
PAGE 2
Need Help? LED Explanation Solid Blue The router is working normally. Circulating Blue The system is starting up or the router is being reset. Circulating Blue in Parallel The firmware is being upgraded or WPS connection is being established. Solid Orange The router is connected to the internet, but the wireless function is off. Solid Red No internet connection.