User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect to the Internet
- Log In
- Configure the Router in Wireless Router Mode
- 4. 1. Status
- 4. 2. Quick Setup
- 4. 3. Operation Mode
- 4. 4. Network
- 4. 5. Dual Band Selection
- 4. 6. Wireless (2.4GHz or 5GHz)
- 4. 7. Guest Network
- 4. 8. DHCP
- 4. 9. Forwarding
- 4. 10. Security
- 4. 11. Parental Controls
- 4. 12. Access Control
- 4. 13. Advanced Routing
- 4. 14. Bandwidth Control
- 4. 15. IP & MAC Binding
- 4. 16. Dynamic DNS
- 4. 17. IPv6
- 4. 18. System Tools
- 4. 19. Log Out
- Configure the Router in Access Point Mode
- FAQ
4
Chapter 1
Get to Know About Your Router
Name Status Indication
(2.4GHz Wireless)
On The 2.4GHz wireless band is enabled.
Off The 2.4GHz wireless band is disabled.
(5GHz Wireless)
On The 5GHz wireless band is enabled.
Off The 5GHz wireless band is disabled.
(Internet)
Green On Internet service is available.
Orange On The router’s Internet port is connected, but the internet is not available.
Off The router’s Internet port is not connected.
(Ethernet)
On At least one Ethernet port is connected to a powered-on device.
Off No Ethernet port is connected to a powered-on device.
(WPS)
On A WPS connection is established.
Flashing A WPS connection is in progress. This may take up to 2 minutes.
Off
A WPS connection has been established for more than 5 minutes or
WPS connection failed.
1. 2. 2. The Back Panel
The following parts (view from left to right) are located on the rear panel.