User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect to the Internet
- Log In
- Configure the Router in Wireless Router Mode
- 4. 1. Status
- 4. 2. Quick Setup
- 4. 3. Operation Mode
- 4. 4. Network
- 4. 5. Dual Band Selection
- 4. 6. Wireless (2.4GHz or 5GHz)
- 4. 7. Guest Network
- 4. 8. DHCP
- 4. 9. Forwarding
- 4. 10. Security
- 4. 11. Parental Controls
- 4. 12. Access Control
- 4. 13. Advanced Routing
- 4. 14. Bandwidth Control
- 4. 15. IP & MAC Binding
- 4. 16. Dynamic DNS
- 4. 17. IPv6
- 4. 18. System Tools
- 4. 19. Log Out
- Configure the Router in Access Point Mode
- FAQ
71
Chapter 5 Congure the Router in Access Point Mode
5. 1. Status
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Status. You can view the current status information of the router.
• Firmware Version - The version information of the router’s firmware.
• Hardware Version - The version information of the router’s hardware.
• LAN - This field displays the current settings of the LAN, and you can configure them
on the Network > LAN page.
• MAC address - The physical address of the router.
• IP address - The LAN IP address of the router.
• Subnet Mask - The subnet mask associated with the LAN IP address.
• Wireless 2.4GHz/5GHz - This field displays the basic information or status of the
wireless function, and you can configure them on the Wireless > Basic Settings page.
• Operation Mode - The current wireless working mode in use.
• Wireless Radio - Indicates whether the wireless radio feature of the Router is
enabled or disabled.
• Name(SSID) - The SSID of the Router.