Installation Instructions

AD7200 Multi-band Wi-Fi Router
Connecting the Hardware
If your internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router’s Internet port, and then follow Step 1, 5 and 6
to complete the hardware connection.
Router
Connect the power
adapter to the router
and turn on the router.
5
AD7200
Power adapter
* The power adapter (American version) is
used for the demonstration in this QIG.
Quick Installation Guide
Modem
Power adapter
Turn off the modem,
and remove the backup
battery if it has one.
2
3
Connect the modem to the
router’s Internet port with an
Ethernet cable.
Turn on the modem, and
then wait about 2 minutes
for it to restart.
4
Internet
Place the router horizontally and extend the
antennas to the maximum angle.
1
Note: For best performance, horizontal installation is recommended.
Antenna direction and position can affect performance in vertical
installation situations.
Verify that the following LEDs are on and solid
to confirm the hardware is connected correctly.
6
Power
On
On
Internet
5GHz
On
2.4GHz
On
60GHz
On
Note:
1. If all the LEDs are off, press the LED On/Off button
for 1 second, and then check the LEDs again.
2. If the 2.4GHz, 5GHz, and 60GHz LEDs are off, press and
hold the Wi-Fi On/Off button for 2 seconds. Wait a
few seconds, all the three LEDs should turn solid on.