User's Guide

84
Chapter 5 &RQƮJXUHWKH5RXWHULQ$FFHVV3RLQW0RGH
for listening to broadcast and multicast messages. When the router has buffered
broadcast or multicast messages for associated clients, it sends the next DTIM with
a DTIM Interval value. You can specify the value between 1-255 Beacon Intervals. The
default value is 1, which indicates the DTIM Interval is the same as Beacon Interval.
•
Enable Short GI - It is recommended to enable this function, for it will increase the
data capacity by reducing the guard interval time.
•
Enable Client Isolation - This function isolates all connected wireless stations so
that wireless stations cannot access each other through WLAN. This function will be
disabled if WDS/Bridge is enabled.
•
Enable WMM - WMM function can guarantee the packets with high-priority messages
being transmitted preferentially. It is strongly recommended to enable this function.
5. 6. 7. Wireless Statistics
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to
Wireless > Wireless Statistics to check the data packets sent and received by
each client device connected to the router.
• MAC Address - The MAC address of the connected wireless client.
•
Current Status - The running status of the connected wireless client.
•
Received Packets - Packets received by the wireless client.
•
Sent Packets - Packets sent by the wireless client.
•
SSID - SSID that the station associates with.
5. 6. 8. Throughput Monitor
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to
Wireless > Throughput Monitor to watch wireless throughput info.