User's Guide

109
Chapter 6
Configure the Router in Range Extender Mode
• DHCP Server - Enable or disable the DHCP server. If disabled, you must have another
DHCP server within your network or else you must configure the computer manually.
•
Start IP Address - Specify an IP address for the DHCP Server to start with when
assigning IP addresses.
•
End IP Address - Specify an IP address for the DHCP Server to end with when assigning
IP addresses.
•
Address Lease Time - The Address Lease Time is the amount of time a network user
will be allowed to connect to the router with the current dynamic IP Address. When
time is up, the user will be automatically assigned a new dynamic IP address.
•
Default Gateway (Optional) - It is suggested to input the IP address of the LAN port of
the router.
•
Default Domain (Optional) - Input the domain name of your network.
•
DNS Server (Optional) - Input the DNS IP address provided by your ISP.
•
Secondary DNS Server (Optional) - Input the IP address of another DNS server if your
ISP provides two DNS servers.
Note:
• To use the DHCP server function of the router, you must configure all computers on the LAN as Obtain an IP Address
automatically.
• When you choose Smart IP (DHCP) in Network > LAN, the DHCP Server function will be disabled. You will see the page
as below.
6. 6. 2. DHCP Client List
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to
DHCP > DHCP Client List to view the information of the clients connected to
the router.