User's Manual
Table Of Contents
- Package Contents
- Chapter 1. About this Guide
- Chapter 2. Introduction
- Chapter 3. Connecting the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
MR4-WR642G 108M Wireless Router User Guide
17
5.4 Network
Figure 5-2 the Network menu
There are three submenus under the Network menu (shown in Figure 5-2): LAN, WAN and MAC
Clone. Click any of
them, and you
will be able to configure the corresponding function. The
detailed explanations for each submenu are provided below.
5.4.1 LAN
You can configure the IP parameters of LAN on this page.
Figure 5-3 LAN
¾ MAC Address - The physical address of the router, as seen from the LAN. The value can't
be changed.
¾ IP Address - Enter the IP address of your router in dotted-decimal notation (factory default:
192.168.1.1).
¾ Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
)
Note:
1) If you change the IP Address of LAN, you must use the new IP Address to login the router.
2) If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the
DHCP server will not take effect, until they are re-configured.
3) If the new LAN IP Address you set is not in the same subnet, the Virtual Server and DMZ
Host will change accordingly at the same time.