User's Manual
Table Of Contents
- TL-WR543G User Guide
- Package contents
- Chapter 1: About this Guide
- Chapter 2: Introduction
- Chapter 3: Connecting the Router
- Chapter 4: Quick Installation Guide
- Chapter 5: Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
- Appendix E: Contact Information
TL-WR543G 54M Wireless AP Client Router User Guide
Figure 5-2 Operation Mode
¾ AP Client Router: In this mode, the device enables multiusers to share Internet from
WISP. All LAN ports share the same IP from WISP through Wireless port. While
connecting to WISP, the Wireless port works as a WAN port in AP Client mode. The
ethernet WAN port is automatically disabled. The WAN Connection Type can be
setup in WAN page by using Dynamic IP, Static IP.
¾ AP Router: In this mode, the device enables multiusers to share Internet via
ADSL/Cable Modem. All LAN ports and the wireless port share the same IP to ISP
through ethernet WAN port. The Wireless port acts same as a LAN port while in AP
mode. The WAN Connection Type can be setup in WAN page by using Dynamic IP,
Static IP, PPPoE, 802.1X+Dynamic IP,802.1X+Static IP, BigPond Cable, L2TP, PPTP.
5.5 Network
Figure 5-3 the Network menu
There are three submenus under the Network menu (shown in figure 5-3): LAN, WAN
and MAC Clone. Click any of them, and you will be able to configure the corresponding
function. The detailed explanations for each submenu are provided below.
5.5.1 LAN
You can configure the IP parameters of LAN on this page.
Figure 5-4 LAN
- 17 -