User Manual

TL-WN310G 54M Wireless Adapter User Guide
- 3 -
Chapter2. Installation Guide
2.1 Hardware Installation
To install the adapter, follow these steps listed below:
1. Locate an available CardBus slot on your laptop.
2. With the connector pin end facing the CardBus slot and the label facing up, slide the
Adapter into the CardBus slot until it locks in place.
3. The Status LED should Intermittent flashing when the Adapter is installed correctly.
2.2 Software Installation
2.2.1 Overview
The Adapter’s Setup Wizard will guide you through the Installation procedure for Windows
2000, XP. The Setup Wizard will install the TP-LINK Wireless Client Utility (TWCU) and
drivers.
When you install the hardware before installing the software, the system will prompt
“Found New Hardware Wizard”, click Cancel, and run the Setup Wizard program on the
CD-ROM.
The Setup steps for Windows 2000, XP are very similar. The following setup steps are for
Windows 2000.
2.2.2 Software Installation for Windows 2000
1. Insert the Resource CD into your CD-ROM drive, Click the Start button and choose
Run. In the field that appears, enter F:\XXX\Setup.exe (If "F" is the letter of your
CD-ROM drive, XXX represents the setup program path, which is labeled on the
Resource CD), then Figure 2-1 will appear.
Figure 2-1
2. You can click Cancel to end the installation in the screen above. Otherwise, the