User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Product Overview
- Chapter 2. Hardware Installation
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the Device in AP Client Router & AP Router Operation Mode
- Chapter 5. Configuring the Device in AP Operation Mode
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
11
Figure 3-9 Quick Setup - Static IP
)
Note:
The IP parameters should have been provided by your ISP.
¾ IP Address - This is the WAN IP address as seen by external users on the Internet
(including your ISP). Enter the IP address into the field.
¾ Subnet Mask - The Subnet Mask is used for the WAN IP address, it is usually
255.255.255.0
¾ Default Gateway - Enter the gateway IP address into the box if required.
¾ Primary DNS - Enter the DNS Server IP address into the boxes if required.
¾ Secondary DNS - If your ISP provides another DNS server, enter it into this field.
3. After you complete the above, click Next, the Wireless settings page will appear below.
Figure 3-10 Quick Setup - Wireless settings
On this page, you can configure the following wireless parameters:
)
Note:
The Quick Setup - Wireless page differs in different modes. If you choose the AP Router mode,
you will see the Wireless page as below