User's Manual
Table Of Contents
- RE350_User Manual-rev4-for FCC.pdf
- 1910011680 _RE350多机型_UG_REV1.0.0.pdf
- Introduction
- Connect the Extender to the Internet
- View the Information of the Extender
- Manage the Extended Network and Security Settings
- Manage the Extender
- Appendix
- RE350_警语
- 1910011680 _RE350多机型_UG_REV1.0.0
- Introduction
- Connect the Extender to the Internet
- View the Information of the Extender
- Manage the Extended Network and Security Settings
- Manage the Extender
- Appendix
- 1910011680 _RE350多机型_UG_REV1.0.0.pdf
- RE350_警语
- RE350_User Manual-rev4-for FCC
- 1910011680 _RE350多机型_UG_REV1.0.0.pdf
- Introduction
- Connect the Extender to the Internet
- View the Information of the Extender
- Manage the Extended Network and Security Settings
- Manage the Extender
- Appendix
- RE350_警语
- 1910011680 _RE350多机型_UG_REV1.0.0
- Introduction
- Connect the Extender to the Internet
- View the Information of the Extender
- Manage the Extended Network and Security Settings
- Manage the Extender
- Appendix
- 1910011680 _RE350多机型_UG_REV1.0.0.pdf
Connect the Extender to the Internet
Connect
Press the WPS button on your router/AP.
Immediately press the WPS button on your extender. The LED
should change from flashing to solid, showing that WPS connection is
successful.
If you are connecting the extender to a dual-band router but only
2.4GHz or 5GHz LED is on, repeat step 1 and 2 again to connect the
other band.
Relocate
Plug the extender into an electrical outlet about halfway between your
router (Host Network) and the Wi-Fi dead zone.
Wait until the LED is lit with a solid blue. If not, relocate the extender
closer to the router to achieve a good (or better) signal quality.
For more information about using WPS on your router,
please refer to the router manufacturer's user guide.
If the RE LED does not change from flashing to solid,
please refer to Using your Web Browser.
Some ISP gateways disable the WPS function by
default, if the WPS method fails, please refer to
Using
your Web Browser.