User's Manual

NC450 HD Pan&Tilt Day/Night Cloud Camera
7
w
all plugsscrews
A) Place the paper drill guide where you want the camera. Check the alignment using a level.
B) Using a 0.24 inch (6mm) drill bit, drill holes through the two circles on the guide. Remove the
paper.
C) Insert the two anchors into the holes. Place the camera mount over the anchor and use the
screws to secure it.
D) Attach the camera.
2
Mount Base
3
Secure Camera
1
Drill Holes
Ceiling Mounting
Get the provided accessories for camera’s wall mounting ready, and follow the instructions below
to mount the camera. After relocating your camera, remember to power on it.
screws wing nuts washers
A) Place the paper drill guide where you want the camera*.
*Camera placement can affect viewing angle. For best results, place the camera near a wall or
corner.
B) Using a 0.24 inch (6mm) drill bit, drill holes through the two circles on the guide. Remove the
paper.
C) Attach the camera mount using the screws, washers, and wingnuts.
D) Attach the camera.