User's Manual
Table Of Contents
- Chapter 1 About this Guide
- Chapter 2 Introduction
- Chapter 3 Managing the Camera
- 3.1 Login
- 3.2 Live View
- 3.3 Basic
- 3.4 Advanced
- 3.4.1 Advanced > Status
- 3.4.2 Advanced > Network
- 3.4.3 Advanced > Wireless Connection
- 3.4.4 Advanced > Wireless Extender
- 3.4.5 Advanced > Cloud Setting
- 3.4.6 Advanced > DDNS
- 3.4.7 Advanced > Video
- 3.4.8 Advanced > Motion Detection
- 3.4.9 Advanced > Sound Detection
- 3.4.10 Advanced > Notification Delivery
- 3.4.11 Advanced > LED
- 3.5 System
- Appendix: Specifications
NC230 HD Day/Night Wi-Fi Cloud Camera
HD Day/Night Cloud Camera, 300Mbps Wi-FiNC25
0
30
FTP
Select FTP, you can configure your camera to send snapshots to a specified FTP sever on the
following screen:
FTP Server/ Port: Enter the IP or the domain (IP/domain without prefix ftp://) and the port of
the FTP server that you will be connecting to. The port is 21 by default.
Note:
The FTP server you set and the camera should be in the same LAN.
Username: Enter the username that is used to log in to your FTP server.
Password: Enter the password that is used to log in to your FTP server.
Path: Enter the path to the destination on the FTP server.
Passive Mode: Enabling passive mode may help you reach your FTP server if your camera is
behind a router protected by a firewall.
To set up a FTP to receive notification, follow the steps below: