User's Manual

NC230 HD Day/Night Wi-Fi Cloud Camera
NC25
0 HD Day/Night Cloud Camera, 300Mbps Wi-Fi
5
 WPS/RESET Button: This button is used for both WPS and RESET function. To use the WPS
function, press it for 1 second. To use the RESET function, press and hold for more than 5
seconds.
 Used as WPS button:
If your wireless router or access point supports WPS (Wi-Fi Protected Setup), you can
connect the camera to your Wi-Fi network using WPS. Press the WPS or QSS button on
your router or access point. Within 2 minutes, press the WPS/RESET button on the
camera, then the LED above this button will start flashing quickly. When this LED
becomes solid on, the WPS is successful.
 Used as RESET button:
With the camera powered on, press and hold the WPS/RESET button (more than 5
seconds) until the System LED turns off. Then release the button and wait the camera to
reset to its factory default settings.
 Heat Emission Holes: These holes are used for heat dissipation.
2.4 Hardware Connection
Connect the camera to the network your computer or smartphone is on.
Computer requirements: Smartphone requirements:
Windows XP or higher
Mac OS X 10.7 or higher
Android 3.0 or higher
iOS 6.0 or higher
Follow the steps below to connect the hardware:
1) Power on the camera using the provided power supply unit as shown.
2) Connect a computer or smartphone to the router as shown.
3) Connect the camera to the router via wired or wireless connection.
Wired: Connect the camera to the router’s LAN port via an Ethernet cable.
Wireless: If your wireless router or access point supports WPS, you can connect the camera
to your Wi-Fi network using WPS. Press the WPS or QSS button on your router or access
point. Within 2 minutes, press the WPS/RESET button on the back of the camera, then the
LED above this button will start flashing quickly. When this LED becomes solid on, the WPS is
successful and the camera is connected to the router wirelessly.