User's Manual
Table Of Contents
- About This Guide
- Get to Know Your Modem Router
- Quick Start
- Log In to Your Modem Router
- Configure Internet Connections
- Network Security
- USB Settings
- Parental Control
- Guest Network
- NAT Forwarding
- Specify Your Network Settings
- Administrate Your Network
- Appendix: Troubleshooting
14
Chapter 4
Congure Internet Connections
• Stateless DHCPv6: Stateless DHCPv6 is a combination of “stateless Address
Autoconfiguration” and “Dynamic Host Configuration Protocol for IPv6” and is
specified by RFC3736. Select the checkbox to enable this function.
4. Click Save to make the settings effective. Now IPv6 service is available for your
network.
4. 2. Test Internet Connectivity
After manually setting up an internet connection, you need to test the internet
connectivity. The modem router provides two diagnostic tools to help you locate the
malfunction.
1. Visit http://tplinkmodem.net, and log in with the password you set for the router.
2. Go to Advanced > System Tools > Diagnostics.
3. Select Ping or Traceroute as the diagnostic tool and enter the parameter according
to your needs.
• Ping is used to test the connectivity between the router and the tested host,
and measure the round-trip time.
Target IP/Domain Name: Enter the IP address/domain name that you want to
ping.
Ping Packet Size: Enter the size of the ping packet you want to use.
Ping Count: Enter the number of times you want to ping the target device.
Ping Interval: Enter the time period between each ping.