Instructions / Assembly

5
Deep-profile use(Figure 2)
A 2-1-in.-deep box can be attached to
blocking between joists and is roomly enough
to handle more than one cable.
Brace use (Figure 3)
Paired with a deep box, this hanger is meant to
span between two joists and takes the place of
wooden blocking.
If your fan is to replace an existing light
fixture, turn electricity off at the main fuse
box at this time and remove the existing light
fixture.
WARNING: To reduce the risk of fire,
electrical shock, or personal injury, mount
fan to outlet box marked acceptable for
fan support of 10 kgs. Use screws
supplied with outlet box. Most outlet
boxes commonly used for support of light
fixtures are not acceptable for fan support
and may need to be replaced. Consult a
qualified electrician if in doubt.
WARNING: Turning off wall switch is
not sufficient. To avoid possible electrical
shock, be sure electricity is turned off at
the main fuse box before wiring. All
wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
WARNING: To avoid fire or shock,
follow all wiring instructions carefully.
Any electrical work not described in these
instructions should be done or approved
by a licensed electrician.
WARNING: Do not operate this fan with
a variable (Rheostat) wall controller or
dimmer switch. Doing so could result in
damage to the ceiling fan's remote control
unit.