Owner's Manual

–65–
X
MANUALE PER IL CLIMATIZZATORE A PARETE
GB
• Remove two screws of valve cover at the right side of the outdoor unit.
Then pull it this side with hook in the back side.
• Insert hook (three parts) of the valve cover to outdoor unit and fix two screws on the body. 14 Drainage
• Be sure to install the drain hose so as to be downward slope. • After finishing the drain piping, check the drainage by pouring some water in the drain pan. • In case that the un-insulated drain hose is through in a room, apply heat insulation to it. • Do not drain as illustrated below
Is heat insulation applied to throughout the pipes? Is the earth line securely connected? Is the indoor unit securely fixed? Is the voltage correct? Is the connecting wirings of indoor and outdoor firmly inserted to the terminal block?
16 Check for installation and Test Run
• Please explain to the customers how to operate the unit through the instruction manual.
Isn’t there any noise? Is the control of temperature set normally? Is the drainage securely carried out? Isn’t there any gas leakage from the pipe connecting? Is the combination of the connecting wirings and pipes correct? * Only for Dual and Triple models.
Up-and-down bending
Hose end is immersed into water.
Waving
Hose end is near a ditch and bad smell may come in the room.
Pull
Screw
Valve cover
Screw
Put check mark in boxes
Hook (Three parts)
Drain elbow
Drain hose
Gum bushing
15 Attachment of drain elbow and gum bushings
Valve cover
Screw
Screw
✔
CAUTION
Check Items for Test run
13
Removing & Attachment of the valve cover (9K, 12k Cooling & Heating models)
• In case of using the drain elbow and gum bushings, attach
them as illustrated.
• Do not attach the drain elbow and gum bushings in cold
districts where the air temperature falls below zero conti- nuously. Frozen drain may cause to stop the fan motor. * Gum bushings are only for 9k, 12k Inverter models and
21k Dual Inverter model.
TAN/TAG-A28IVF.qxd 11.2.16 4:53 PM ページ 65