HEAVENLY Un Unlit tin! FLEECER COIFS ROUT SHOULD BE OBSERVED DUNG FAILING USE TOPREVTELETRCSHOK INSTRUCTION SHEET AGES 8+ TOY MAX INC. : FCC ID : NLKTMIS0888C27 IMPORTANT: JOB : 883U1 PLEASE READ THESE INSTRUCTIONS EXHIBIT#: 5 PRIOR TO USING 4.0! PLEASE KEEP THIS SHEET FOR FUTURE REFERENCE! HELPFUL TIPS: 1. FOR VOICE COMMAND TO WORK, YOU MUST SPEAK SLOWLY AND CLEARLY! 2. THE MORE YOU USE RAD.™ 4.0 THE BETTER YOU WILL BECOME AT MAKING RAD.™ 4.0 UNDERSTAND YOU! 3. IFRAD.™ 4.
INSTALLING THE BATTERY INTO RAD.™ 4.0: Insert a FULLY CHARGED 8V Ni-Cd battery into your RAD.™ 4.0 as shown ~ be sure the polarity is correct. 1} Insert the battery pack (label side out) with the arrow pointing down. 2) Position the battery at the top of the battery compartment & slide it downward to snap it into place.Tum the lock at the top of the battery compartment to secure the battery. Close cover. To remove battery pack, unlock and slide battery up.
WHERE YOU CAN USE RA.D.™ 4.0: INDOORS: ed RAD.™ 4.0 Robot will work on most surfaces including flat floors, tile, and low-pile carpet. OUTDOORS: RAD.™ 4.0 Robot can be used outdoors on clean, flat surfaces. Do nat run RAD.™ 4.0 Robot through WATER or SAND this can damage RA.D.™ 4.0's electronics and gears. OPERATING YOUR 4.0 ROBOT: VOICE COMMAND MODE: Command Mode is the mode where you control RAD.™ 4.0 with VOICE COMMANDS. WHENEVER THE CONTROLLER IS IN RAD.™ 4.0°S HEAD, RAD,™ 4.0 is in Command Mode! RAD.
“DRIVE” COMMAND: & me Drive Command will put RAD. 4.0 into DRIVE MODE. ® RAD.™ 4.0’ head will open and you can take the controller out. oS You can now control RAD.™ 4.0 with the hand controller. @ RA.D.™ 4.0 WILL NOT BE IN DRIVE MODE UNTIL THE CONTROLLER 1S REMOVED FROM HIS HEAD! NOTE: Be sure to raise the ANTENNA on the controller! TO DRIVE 4.
“SPY” COMMAND: @ re Spy Command will put RAD™ 4.0 into SPY MODE. @ sPv MODE is EXACTLY the same as DRIVE MODE, only RAD™ 4.0 will be silent. NOTE: In DRIVE and SPY MODE YOU are controlling RAD. 4.0 with the Radio Control Unit interference can be caused by a variety of devices both inside and outside. if RA.D.™ 4.0 Robot does not seem to be responding to the signal from the transmitter, try using 4.0 in a different location or at a different time. “GUARD” COMMAND: oe The Guard Command will set RA.D.™ 4.
LEVEL 1 SPEECH TREE CHART 4.0 (or ASSIGNED NAME) LEVEL 2 RA.D.™ 4.0 will reply "READY FOR COMMAND" EE 1 LEVEL SQUARE 2. CIRCLE 3. FIGURE EIGHT 4. DANCE 1.GO 2. FORWARD i 1. SING 2. CRASH 3. HAPPY BIRTHDAY 4. BOOGIE 5. GET DIZZY 6. QUESTION 3. RIGHT 4. LEFT 5. TURN AROUND 6. ABOUT FACE een 7. DO SOMETHING Call: 1-800-222-9060 ann eee Amt Eri SEY Flt art he rent, Beyer oe nobble toes 7. BACKWARD Back to LEVEL < < < Back to LEVEL Back to LEVEL 1 12. GROOVE This device complies with Port 15 of the £CC Rules.
