Owner manual

ManualsBrandsToxalert ManualsAir equipmentCM203

CARBON MONOXIDE MONITOR MODEL CM200 SERIES

TYPICAL APPLICATIONS:

• Parking Garages • Fire Stations

• Vehicle Maintenance Shops • Police Stations

• Car Dealers • Post Offices

• Warehouses • Ice Arenas

FEATURES:

• Self-Checking feature for sensor failure

• Sensor LED indication

- Operation Normal - Power ON

- Warning Stage - Alarm Stage

• Completely solid state for long life

• Relay outputs for control and alarming

• User adjustable Warning Level

GENERAL DESCRIPTION:

TOXALERT’S Model CM200 Series monitors are

compact, solid-state, low maintenance, cost effective

carbon monoxide monitors designed for fixed installation,

continuous monitoring.

The Model CM200 Series consists of three separate

monitors. Model CM201 has a single stage audible alarm;

Model CM202 has two stages of relay outputs, and Model

CM203 has a first stage relay output and a second stage

audible alarm. All models are microprocessor based with

temperature and humidity compensation for stability. The

solid state semiconductor-type sensor and associated

electronics ensure trouble-free, long-term operation, for

there are no pumps, filters or chemical cells to replace or

maintain.

TOXALERT INTERNATIONAL, INC., P.O. BOX 159, MOUND, MINNESOTA 55364 (952) 472-4541 FAX (952) 472-4960

Visit our website at www. toxalert. com

TOXALERT

DATA

SHEET

CM202

• User adjustable Alarm Level

• Operating range meets OSHA std. 1910.1000

• Compact Nema 1 enclosure

• No maintenance except periodic calibration

checks

Summary of content (4 pages)

PAGE 1
TOXALERT DATA TM SHEET CARBON MONOXIDE MONITOR MODEL CM200 SERIES TYPICAL APPLICATIONS: • Parking Garages • Vehicle Maintenance Shops • Car Dealers • Warehouses • Fire Stations • Police Stations • Post Offices • Ice Arenas GENERAL DESCRIPTION: TOXALERT’S Model CM200 Series monitors are compact, solid-state, low maintenance, cost effective carbon monoxide monitors designed for fixed installation, continuous monitoring. The Model CM200 Series consists of three separate monitors.
PAGE 2
OPERATION: The Model CM200 series has a two color LED (light-emitting diode) to indicate its operating status. When the LED is flashing green, operation is normal and unit is not in alarm. When the LED is flashing red, the unit is sensing CO above its setting. A continuous red or green indicates failure; and LED off indicates power failure. Model CM201 is a single stage carbon monoxide monitor with audible alarm.
PAGE 3
INSTALLATION INSTRUCTIONS: CM200 SERIES CO CONTROL UNIT Field Wiring Diagram 1. INSTALLATION: Refer to Figure 1 and 2 to install and wire the Toxalert monitor as follows: 1.) Locate a mounting location away from direct fresh air intakes, and mount vertically on wall or support column approximately five to six feet above floor. 2.) Open door and remove circuit board and sensor from enclosure. 3.) Mount enclosure with hinge along left side by using mounting holes (4 are available). 4.
PAGE 4
3. BURN-IN: Burn-In period allows sensor to stabilize before applying power to remote device(s) connected to models CM202 & CM203. 1.) Be sure power is off to remote devices and monitor supply power is turned on. 2.) Allow sensor to burn-in for a minimum of 72 hours with power turned on to monitor. Monitor may go in and out of alarm during burn-in. 3.) When 72 hours have elapsed, confirm remote device(s) wiring and turn power on to remote devices. 4.