Operating Instructions

TowBrite Inc.
www.towbrite.com
613-366-1584
[e-mail]
Quality Wireless Tow Lights
Made in Canada
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules[and ISED Radio Standards Specifications]
CFR 47 FCC PART 15 SUBPART C[and RSS-247 Issue2] has been investigated. It is applicable to the
modular.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in a host,
host manufacturer have to consult with module manufacturer for the installation method in end system.
2.4 Limited module procedures
This module is Limited single modular without shielding, host manufacturer have to consult with module
manufacturer for the module limiting conditions when integrate the module in the host. module
manufacturer should reviews detailed test data or host designs prior to giving the host manufacturer
approval.
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
The device has been evaluated to meet general RF exposure requirement in portable exposure condition
without restriction.
L'appareil a été évalué pour répondre aux exigences générales d'exposition aux radiofréquences.
L'appareil peut être utilisé en condition d'exposition portable sans restriction.
2.7 Antennas
This radio transmitter FCC ID: 2AWK3-TBR433TX [IC: 26388-TBR433TX] has been approved by Federal
Communications Commission to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
Antenna No.
Operate frequency band
Antenna Type
Maximum antenna
gain
Antenna 1
2.4GHz – 2.5 GHz
Integral Antenna
0.0 dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID: FCC ID:
2AWK3-TBR433TX” [“Contains IC: 26388-TBR433TX”]
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for the
transmitter when the module is installed in the host…
2.10 Additional testing, Part 15 Subpart B/ Canadian CAN ICES-003 (B) disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other
applicable requirements for the system such as Part 15 B/ ICES-003 (B)….