Installation Instructions

Dimmer Red wire (Line-Out/Load) connects

to Black-Wire going to the light ﬁxture

Red

Dimmer Green Wire GND connects to

ground wires in the electrical panel box.

Green

Once the power is turned on by ﬂipping the Circuit breaker you will see bottom

White-LED blinking and lights turns ON. It means dimmer is connected right and is

ready to control lights. User now can operate the dimmer by swiping ﬁnger up and

down on the touch panel (‘Center Middle Portion on the dimmer surface’) over the

LEDS and experience light dimming or turning Oﬀ & On. LEDS indicate proportional

intensity control (Scale 0 to 100%).

Bottom Blinking Led indicates WiFi configuration is not completed

and smart-features are not yet enabled.

Step 3:

Power ON Circuit Breaker to continue installation of the iotGizmo

Touch Dimmer

Power ON Circuit Breaker to continue installation of the iotGizmo

Multi Dimmer

Step 3-A:

Step 3-B:

Down