Installation Instructions

Bare copper or green color conductor is GND wire which is grounded to
the main panel. Remove all three wires and mark supply (Line-In) & fixture
black wires (Line-Out) with pen or and electrical tape. Use electrical caps
on live wires to prevent accidental touching or shorting of the circuit.
Electrical Circuits with 120V AC are HAZARDOUS and could kill people by
electrocu- tion. Only certified electrician shall perform the replacement or
installation of Smart Dimmer. It is essential to turn-off the breaker supplying
power to the switch being replaced with smart dimmer
Figure A. Shows a typical residential electrical wiring of a switch. Two black
wires are generally Line-In from the panel/breaker (Top Black) and bottom
black wire Line-Out supplies electricity to the light fixture. Some old houses
Line-In and Line-Out may be reversed. In such case use electrical tester to
find Line-In by turning switch off. Tester indicating power is Line-In or supply
wire and the other Line-Out is connected to the fixture. Now turn off the
breaker and install smart dimmer.
AFigure
B
Step 1:
Remove Old Switch/Dimmer
Caution
!
Figure
Figure B. Shows how to connect wires for the ‘Smart Dimmer D6932’.
Dimmer Black wire connects to
Line-In or Supply from Panel/breaker.
Black
Step 2:
Smart Dimmer Electrical Connections
Dimmer White wire (Neutral) connects to
group of white wires generally capped in
the electrical box and tucked on the back
side and is connected to panel/breaker.
White