Installation Instructions

Advanced features are provided to automate light
controls in order to save energy and for your

feature to add and remove other dimmers in a
group. These features are all configured in the
dimmer settings screen as shown below.
If you are unable to configure WiFi and the
device is in WiFi setup mode, check your
router password is correct and also your router
and smartphone are compatible to work with
2.4GHZ WiFi frequency.
Also make sure you have decent WiFi signal
strength at the location where this dimmer is
installed. Generally metal boxes and metal
surface-wall-plates hinder WiFi signals. WiFi
antenna is mounted on the top front portion of
the dimmer for optimal WiFi reception. If
possible, use a plastic switch cover plate.
Repeat the procedure once again by resetting
power and/or rebooting the dimmer.

LTE

95 %
Turns light off automatically when away from set address
Turns light on automatically for a set interval
Turns light off after a set time
DEVICE
VACATION AWAY - Turns light on and off automatically at set times when away
Kitchen Dimmer
Group settings
ON / OFF

ON / OFF
ON / OFF 
INTENSITY


HOURS 
HOURS
ON / OFF
 
Step 7:
Advanced features such
as Lighting schedules etc.
Diagnostics and trouble shooting
1.
2.
3.
Dimmer Reboot/Reset:
By gently touching or
pressing the middle of the
airgap toggle lever at the
bottom.
4.
Changing Light bulbs
The Airgap breaker
disconnects power
output to the light fixture
and must be pulled out
when changing light
bulbs. Once Light bulbs
are changed, push airgap
switch back into position
for the lights to operate.
5.