Dimensions Guide

TET2GA
ECOPOWER
®
Toilet Flush Valve, 1.6 GPF
#SS-01165, v.02
Ph: (888) 295-8134 | Fax: (800) 699-4889 | www.totousa.com | © TOTO USA
These dimensions and specifications are subject to change without notice
SPECIFICATIONS
*Water pressures over 80 psi are not recommended for most plumbing
fixtures. Check your local plumbing code for details.
INSTALLATION NOTES
Material Bronze casting
Power supply ECOPOWER
Sensor detection time Factory setting at six
(6) seconds minimum
Sensor detection range Self-adjusting to
environment
Discharge quantity Preset to 1.6 GPF/
6.0 LPF
Operating temperature 32°-104°F (0°-40°C)
Water supply pressure 15 psi - 125 psi*
Water supply connection 1" NPT
Warranty Three year limited
For commercial applications only.
Warning: Failure to properly adjust angle stop to
the appropriate level can potentially cause property
damage.
For detailed installation instructions, please refer to
the installation manual.
Max flow rate to be used with
TET2GA___________: 1.6 GPF
Confirm with local codes and standards for floor drain
requirement. Adjust control stop for proper flow rate
to the fixture.
The recommended installation for the flush valve is
to have a 7" (178mm) minimum space in wall. Do not
place grab bars in front of sensor for ADA stalls.
DIAGRAM
Left water supply
1” NPT (toilet), 3/4” (urinal)
4-3/4” ± 1/2”
(120 ± 13mm)
Sensor Location
3-7/16” (87mm)
** 11-15/16”
(303mm)
16” (406mm)
3/4” (19mm)
Stud
Toilet top spud
Ø2-3/16” (Ø56mm) hole
Urinal Back spud
Ø1-5/16” (Ø33mm) hole
Toilet Back spud
Ø2-3/16” (Ø56mm) hole
11” (279mm)
CL of sensor
* X”
** 13-1/2”
(343mm)
* 14-3/4”
from top of
xture (toilet)
Urinal top spud
Ø1-1/2” (Ø38mm) hole
* X”, ‡ = At least 5” clearance from sensor to tip of toilet seat up position or
to top of grab bar is required to avoid false detection.
** Opening in wall
Right water supply
1” NPT (toilet), 3/4” (urinal)
12-5/8” (320mm)
11” (280mm)
14-3/16” (360mm)
12-5/8” (320mm)
11-7/8” (301mm)
11” (280mm)
13-3/8” (340mm)
12-5/8” (320mm)
33-1/2"
(850mm)
15°
Max 19-11/16”
(Max 500mm)