Installation Sheet

TEST RUN

NOTE TO THE INSTALLER

PERIODIC MAINTENANCE

1. For Toilet: Sit on the toilet seat.

For Urinal: Stand within two feet from the front of the Flush Valve.

2. Stay there for 6 seconds or more and then leave the toilet seat or the urinal. The valve

will automatically ﬂush.

3. Press the manual ﬂushing button and make sure the valve ﬂushes properly and the sensor

red light of the sensor is on for 2 seconds.

4. Recheck all the pipe connections for water leaks. If the Flush Valve is not operating

properly following the test run consult the Troubleshooting section on p.12.

After the Flush Valve unit has been installed correctly, please explain to your customer how to

use it and tell them to observe the following instructions:

1. Do not put any object in front of the sensor window which could obstruct the sensor,

causing it to malfunction.

2. In case of any trouble, consult the troubleshooting section on p.12. If you lack the

necessary skills required or have difﬁculty following the directions for installation,

maintenance, repairs, troubleshooting or adjustments of the product, do not proceed

without help from a qualiﬁed person to assist you.

Please check your EcoPower Flush Valve at least once a month according to the

following instructions to avoid risk of property damage.

Check the piping to see whether there is any leakage.

Press the manual ﬂushing button and make sure the sensor red light is on for 2

seconds to see if the generator performs properly

or not.

If the red light is not on, check the generator to see

if any debris is clogged up at the turbine.

ENGLISH