Owner Manual
8
Safety Precautions (Continued)
CAUTION
Do not pour hot water into the toilet.
Doing so may result in damage to the toilet, injury or water damage.
Do not fl ush anything other than bodily waste and toilet paper. Also, do not
fl ush too much toilet paper.
Doing so may clog the toilet, causing waste water overfl ow and water damage.
If a water leak should occur, always close the shutoff valve.
When the ambient temperature is likely to drop to 0°C (32°F) or lower,
prevent damage to the pipes and hoses due to freezing.
Frozen water pipes could cause the top unit and the pipes to break, resulting in a water leak.
Regulate the room temperature to prevent the pipes and hoses from freezing during cold months.
When not using the Washlet over an extended period of time, drain the water
out of the top unit and the water supply hose after closing the water shutoff
valve, and pull the power plug from the outlet.
When using the product again, allow the product to refi ll with water fi rst.
Otherwise, the water in the tank might become contaminated and cause skin infl ammation or
other problems.
(Refer to Page 53 for instructions on replenishing the water.)
Leaving the power on may cause fi re or heat.
When installing the water fi lter drain valve, make sure that it is securely
tightened in its proper position.
Failure to securely tighten it may cause a water leak.
If the bowl unit is clogged, disconnect the power plug and remove the clog.
If the auto fl ush were allowed to function, it would make the wastewater in the bowl unit overfl ow
and may result in water damage.
Use commercially available tools that are made for unclogging the bowl unit to remove the clogging.
Always fl ush, even after just urinating.
Failure to do so may cause inadequate fl ushing or clogging of the bowl unit, resulting in waste
water overfl ow and water damage.
Wipe condensation on the bowl unit, tank, water supply pipe and shutoff
valve with a dry cloth.
Condensation may cause staining and corrosion of the fl oor.
Ventilate the restroom to prevent condensation.
Wipe any urine, condensation, cleaner, water, etc. that has gotten on the
fl oor with a well-wrung mop or cloth.
Failure to do so may cause staining and corrosion of the fl oor.