Owner Manual

ManualsBrandsToto ManualsBathroom Remodel & Bathroom FixturesDrake® Two-Piece Elongated Dual Flush 1.28 and 0.8 GPF Universal Height Dynamax Tornado Flush® Toilet With CEFIONTET® With Wax Ring and Toilet Mounting Bolts (Seat Not Included)

ENGLISH

BEFORE INSTALLATION

Read these instructions thoroughly before beginning work.

Please leave instructions for customers. These instruction contain maintenance

and warranty information.

If necessary, remove the existing toilet.

For your new TOTO toilet to ﬁt correctly, the rough-in, the distance between the

ﬁnished wall to the center of the

closet ﬂange, must be at least

12 inches for most models.

NOTE: Models with 10”

rough-in have model numbers

ending with “.10”, for example

CT746CUFG.10.

Recommended water supply valve location:

5-7/8” (from oor) x 4-3/8” (from center).

Water

Supply

Valve

Finished Wall

"RI"

C/L

Closet

Flange

INSTALLATION PROCEDURE

Ill. 1

Bolt Cap

Nut *

Washer *

Base Cap

Bowl Base

Three Points of Contact

* Not Supplied

Ill. 2C

Ill. 2B

1) Clean any debris out of the closet ﬂange

and then install new mounting bolts

(not supplied) into the slots of the closet

ﬂange (see Illustration 1). The head of the

bolt should be inserted into the slot with

its threads facing upward.

2) Carefully turn the toilet upside down

onto some padding. Firmly press a new

bowl wax ring (not supplied) onto the

circular recess around the toilet bowl’s

horn (see Ill. 2A). Turn the toilet upright

and gently lower into position over

the closet ﬂange. With toilet properly

aligned, press rmly on both sides

of toilet rim to set the bowl wax ring.

(see Illustration 2B)

CAUTION: Do not move the bowl after

the bowl wax ring is set. Thread the base

caps, washers and nuts and tighten evenly

until bowl is snug to closet ﬂange. Install

the bolt caps (see Illustration 2C).

CAUTION: Do not over-tighten the nuts

as damage to the china bowl may result.

Ill. 2A

Points of Contact

(3)