Installation Guide

4
ENGLISH
BEFORE INSTALLATION
 Read these instructions thoroughly before beginning work.
 Please leave these instructions for customers. These instructions contain mainte-
nance and warranty information.
 If necessary, remove the existing toilet.
INSTALLATION PROCEDURE
In order for your new TOTO® toilet to fit correctly, the distance between the finished
wall to the center of the closet flange must be at least 12 inches. This measurement is
called the Rough-In.
Supply
Valve
Finished Wall
"RI"
C/L
Closet
Flange
1. Clean any debris out of the closet flange and
then install new mounting bolts (not supplied)
into the slots of the closet flange (see Ill. 1). The
head of the bolt should be inserted into the slot
with its threads facing upward.
2. Carefully turn the toilet upside down onto some
padding. Firmly press a new bowl wax ring
(not supplied) onto the circular recess around
the toilet bowl’s horn (see Ill. 2). Turn the toilet
upright and gently lower into position over the
closet flange. With toilet properly aligned, press
firmly on both sides of toilet rim to set the bowl
wax ring.
C AUTION: Do not move the bowl after the bowl
wax ring is set. Thread nuts and tighten evenly until
bowl is snug to closet flange. Install the bolt caps.
C AUTION: Do not over-tighten the nuts as damage to
the china bowl may result.
Ill. 1
IMPORTANT!
Due to the powerful performance of our Cyclone, G-Max, E-Max and Power Gravity
flushing systems, they are not specified for back-to-back installations. The only
means of installing these toilets in a back-to-back situation is when the toilet drain
connections incorporate a WYE fitting. Please contact your builder or contractor prior
to this installation.
Double Combination WYE / 1/8 Bend
YES
Double Sanitary Tee / Sanitary Cross
NO
Wax Ring
Horn
Ill. 2