Owner's Manual

6
totemacoustic.com
1. AMP IN
This input bypasses the internal
preamplifier to facilitate connecting
external streaming components.
2. Phono/Line
For all modern electronics this should
be left in the “Line” position. When
connecting a turntable equipped only
with a Phono output, set this to
Phono.
3. Ground
This is used only with turntables
equipped with a ground cable.
4. Aux 1
You can connect this analog input to
the analog output of your TV, cable
box, satellite, game, turntable, or
whatever device you’d like to connect.
5. Aux 2
This 3.5mm input can be used with
many portable devices and
computers.
6. Sub out
This allows you to connect a Totem
Acoustic powered subwoofer to your
speaker to add thunderous bass and
enhance the low frequency effect.
7. Digital In Optical
Sometimes referred to as Toslink or SPDIF, this digital input allows the use of an optical
wire from your TV, cable box, satellite, game, or whatever source you’d like to connect.
8. Power
This will turn the speaker on and off. Make sure to make all your connections before turning the speaker on. You
only need to turn this switch on once, it will then go into standby mode when it is not in use.
9. AC Input
The supplied power cord connects here, plug the other side into a wall receptacle or power bar.
10. Right Speaker Output
Connect the supplied speaker wire from here to the right speaker’s input. Be sure to maintain the polarity of the wire,
keeping the positive and negative signals consistent to ensure best performance.
REAR CONNECTIONS