Owner's Manual

10
totemacoustic.com
TROUBLESHOOTING GUIDE
No Sound

Check to see if the MUTE s etting has been engaged.
 Make sure the corre ct source has been selected.

Verify that the system is powered up and properly connected.
No Power/No light in the LED:
 Verify the main power switch on the amp has been turned on.

Verify that the wall AC outlet is functional.

Check to see the power cord is securely connected.
Cannot connect to Bluetooth

Ensure the Bluetooth input has been selected, signified by a solid blue light.

Confirm the speakers are in pairing mode, s ignified by a flickering blue light.

On the Bluetooth device, turn the Bluetooth function on an d off.

If the device doesn’t find the speakers in pairing mode, turn the speakers off and then on again.
Sound from one speaker only

Verify the speaker wire is securely attached.

Check the interconnects o f the attached sources.

Try a different source to see if the issue is common to all sources.
Remote Control Issues

Check to see if the transparent film separating the battery from the connections has been
removed.

Be sure that you are within range (approximately 30ft). Aim the remote at the active speaker.

Replace the battery.
Low Output

Some sources can play louder than others, verify if a ll sources have the same output.

Many sources, like phones o r tablets, have the ir own volume controls. Ensure th eir volumes are
set to higher levels.

See if both speakers are playing.
Distortion, Poor Quality
 Verify the po larity of speaker connections. Incorrect connections can cause a lack of bass or
image.
 Bass and treble setting might be misadjusted, push the reset button on the remote.

Sources must be set to stereo, not a surround effect like Dolby or DTS.
No Subwoofer Output

Verify that the wire is securely connected.

Make sure that the proper input is being used on the subwoofer.
 If the subwoofer is on and p rope rly connected, increase its volume.