Owner's Manual

8
totemacoustic.com
A powered subwoofer can be easily added by
connecting a single RCA cable from the Sub Out on the
KIN AMP to the Input on the subwoofer. This wire is not
included. Adding a Totem subwoofer will substantially
add to the bass capabilities of the system.
Use the appropriate audio cable to then connect your other sources. Totem has supplied an
Optical and Mini jack cable to cover most requirements.
If you are connecting a turntable, use the RCA inputs of Aux 1. If your turntable is equipped
with a ground wire as well, connect it to the grounding post
on the speaker. If the turntable has a built in Phono Pre-
AMP, set the switch located below the input to Line. If it
does not, set it to Phono. ATTENTION: Be sure to use
the right setting and consult your turntable’s manual.
Using the wrong setting can damage your speakers
and void the warranty.
When you have completed all your connections, connect the power plug from the AMP to the
wall socket and set the master power switch to ON.
The AMP IN input bypasses the internal
preamplifier so features like volume and source
select will not function. This facilitates connecting
and the functionality of external streaming
components and is used primarily in custom
installations. It is a 3.5mm jack so if the streamer is
not equipped with the same output, use the proper
adaptor as required. Once connected, the amp will
be controlled by the connected device.
When no audio input has been detected for 60 minutes, the KIN AMP with go into Standby
mode. It can automatically turn back on by playing the last source that was used. KIN AMP can
be “woken” by pressing the standby button on the remote or the far left or right sections of the
display.
CONNECTING A SUBWOOFER
CONNECTING SOURCES
STANDBY AND AUTO ON
AMP IN / CONNECTING A STREAMER