Owner's Manual

6
totemacoustic.com
1. Aux 1
You can connect this stereo analog input to the analog output of your TV, cable box, satellite, game, turntable, or
whatever device you’d like to connect.
2. Phono/Line
For all modern electronics this should be left in the “Line” position. When connecting a turntable equipped only with a
Phono output, set this to Phono.
3. Ground
This is used only with turntables equipped with a ground cable.
4. Bluetooth Antenna
The antenna captures the Bluetooth signal. Position it vertically for the strongest signal, but it can remain horizontal.
5. Aux 2
This 3.5mm input can be used with many portable devices and computers.
6. Sub out
This allows you to connect a Totem Acoustic powered subwoofer to your speaker to add thunderous bass and
enhance the low frequency effect.
7. Aux 3 Optical
The digital Optical input, sometimes referred to as Toslink or SPDIF, allows the use of an optical wire from your TV,
cable box, satellite, game, or whatever source you’d like to connect.
8. Amp IN
This input bypasses the internal preamplifier to facilitate connecting external streaming components. This is used
primarily in custom installations.
9. Speaker Outputs
Connect the speaker wire from these outputs to the corresponding speakers. Be sure to maintain the polarity of the
wire, keeping the positive and negative signals consistent to ensure best performance.
10. Main Power
This will turn the AMP on and off. Make sure to make all your connections before turning on the AMP. You only need
to turn this switch on once, it will then go into standby mode when it is not in use.
11. AC Input
The supplied power cord connects here, plug the other side into a wall receptacle or power bar.
12. Voltage Selector This selector can be manually switched between 115v and 230v, based on the voltage of
where you live. The KIN PLAY will be set to the country’s voltage where it is sold. DO NOT CHANGE THE SETTING
OR YOU WILL DAMAGE THE AMPLIFIER!
REAR CONNECTIONS