LCD-703HD Series High Definition 7.0” TFT LCD Monitor Model : LCD-703HD (Stand Alone) Model: LCD-703HD2 (19” Rack Mount unit) www.totevision.
The LCD-703HD Series features our completely Digital million pixel TFT LCD high resolution screen, excellent color reproduction. Analog signals are digitized using an advanced 10 bit process with 4x over sampling and adaptive 5 line comb filter plus exacting color space conversion. Video is scaled to fit on screen in the highest resolution using a state of the art Triple gate technology LCD panel that incorporates with precision Gamma correction to product the best images available.
Display (Viewing Area) 7" (6.0" × 3.6") Resolution (Pixels) 800 H × RGB × 480 V Dot Pitch 0.1905mm × 0.1905mm Brightness (in cd/m²) 350 cd/m² System NTSC/PAL auto recognition Inputs 1 Composite, 1 Component HD/SD in/OUT, S-Video IN/OUT , DVI Dimensions 6.85"W × 5.24"H × 1.38"D Approx. Weight 0.7 Kgs(with Remote excluding packing) Power Consumption DC 12V 400 mA (run @ 5-20 VDC) 1.
5 Electrical Specifications Display (Viewing Area) Viewing Angles Resolution (RGB Dots) Contrast Ratio Gamma Luma Linearity Dot Pitch Pixel Response Screen Refresh Rate Backlight Type / Life Brightness System Inputs Active Outputs 7” (6.0”H × 3.6”V) (152.4mm x 91.44mm) 130°H x 120°V 800H x RGB x 480V (1.2 million pixels) 300:1 2.2 Typical +/- 3% with 5 ire increments (0 to 10 ire) 0.1905mm H x 0.
7 LCD Panel Cleaning When cleaning the LCD Panel it is very important to use non-abrasive and ammonia free cleaning agents and a clean micro fiber clothe, or cheese clothe. Do not use paper towels. Paper towel fibers are coarse and may scratch the surface of the LCD screen. Paper towels may also leave streaks on the surface. Antistatic and fingerprint resistant cleaning agents are recommended. Operational Setup 1. Unpack the LCD-703HD and accompanying remote control.
Composite Video IN/OUT DC INPUT *RS-232 TALLY In S-Video IN/OUT DVI INPUT Component IN/OUTPUT * 9pin D-Sub Connector pin assignment RS-232 /TALLY pin configuration RS-232 TALLY 5 4 3 2 1 GND NC T/X R/X NC 9 8 7 6 GND Green RED Yellow TALLY SYSTEM - The tally system on the LCD-703HD is accessed via the DB-09 connector on the back of the unit labeled ‘RS-232/TALLY’. The system works by closing the contacts between the ground pin and the corresponding LED pin.
Applicable signal format Signals Frames per Second 525-60i 480i 625-50i 480P 30/29.97 60/59.94/50 25 60/59.94/50/30/29.97 /25/24/23.976 60/59.94/50/30/29.97 /25/24/23.976 60/59.94 60/59.94/50/48/47.96 30/29.97/25/24/23.
Model numbers of LCD-703HD Series LCD-703HD LCD-703HDL LCD-703HDX LCD-703HDL back LCD-703HD1 (single unit) LCD-703HD2 (two units)
