User's Manual

42
CAUTION: The panel may be damaged if the wrong batteries are
installed. Make sure the batteries are all the same type
and part number.
NOTE: Use only the following batteries:
Alkaline:
Eveready E91, Duracell MN1500, Panasonic AM3X
NiCd:
Panasonic P-70 AAS or P-60AA, Sanyo N-600-AA
■
To replace the panel’s backup batteries:
1. Enter ACCESS CODE + 1 to disarm the system to level 1. An alarm will occur if you
do not disarm the system.
2. Loosen the two screws on the bottom of the panel until you are able to slide the door
down and out (see Figure 5). Two full turns should be enough to allow you to remove
the battery door without removing the screws completely.
Figure 5
. Loosen the two battery door screws
3. Check the battery type installed (NiCd or alkaline). You must use the same battery
type that is currently installed (see Figure 6).
P
OWER
R
EADY
S
TAY
A
WAY
N
O
D
ELAY
T
ROUBLE
12
3
45
67
8
90
NICAD
ALKALINE
USE ONLY
BATTERY CAPACITY FOR
BATTERY DOOR SCREWS