User's Manual

19
■ To disarm the system from a Keychain Touchpad:
1. Enter the premises through a delay door when the system is armed to level 2
or 3.
The panel and interior sirens sound entry delay beeps for the entire delay or
until you disarm the panel. You must disarm the system before the delay
time expires or an alarm occurs.
CAUTION: Exit the premises immediately if the two- or three-
beep sequence sounds at a more rapid pace.
This indicates an alarm has occurred. Call for
emergency help from a neighbor’s phone.
2. Press the Disarm button on the Keychain Touchpad.
The AWAY or STAY light turns off, and the panel and interior sirens sound
one short beep.
NOTE: Pressing the Disarm button will not disarm the system if an
alarm was generated by simultaneously pressing the arm
and disarm buttons.
CAUTION: If you disarm the system before entering the
premises, do not enter the premises if you hear a
two-beep continuous sequence (1 long, 1 short).
This indicates an alarm has occurred. Call for
emergency help from a neighbor’s phone. For
more information on this feature, contact your
security consultant.
3. Press the
STATUS
button to learn if there are any system problems.
■
To disarm the system using a Magic Key:
1. Enter the premises through a delay door when the system is armed to level 2
or 3.
The panel and interior sirens sound entry delay beeps for the entire delay or
until you disarm the panel. You must disarm the system before the delay
time expires or an alarm occurs.
CAUTION: Exit the premises immediately if the entry delay
beeps sound at a more rapid pace. This indicates
an alarm has occurred. Call for emergency help
from a neighbor’s phone.
2. Insert the Magic Key into the panel key slot (see Figure 3).