User's Manual

16
access code each time you change your primary access
code.
Temporary Access Code
The temporary access code allows you to perform all system commands except
changing access codes and bypassing sensors directly. The system allows you to
have one temporary access code. You might give the temporary access code to a
babysitter or other service personnel.
■
To add or change the temporary access code:
1. Enter primary
ACCESS CODE + STATUS + 7.
The panel beeps once.
2. Enter the temporary
ACCESS CODE.
After five seconds, the panel announces, [temporary access code] OK,
indicating that the temporary access code was changed.
■
To disable the temporary access code:
1. Enter primary
ACCESS CODE + STATUS + 7.
The panel beeps once.
2. Enter the primary
ACCESS CODE.
After five seconds, the panel announces, [primary access code] OK, indi-
cating that the temporary access code was deleted.
NOTE: If your temporary access code is disabled, then changing
your primary access code will automatically make your
old primary access code the new temporary access
code. If you want the temporary access code to remain
disabled, you must disable it again using your new primary
access code each time you change your primary access
code.
Secondary Access Codes
Secondary access codes allow you to perform all system commands, except
changing access codes and bypassing sensors directly. You can have up to four
secondary access codes. The secondary access codes can be used in the same way
as the temporary access code, except the secondary access codes can only be set
and changed by your security consultant.