Use and Care Manual

•4• •5•
4. Put the Juice Auger (4) into the strainer
5. Fit the Hopper (5) over the Juice bowl and turn in position so it locks into the
main body.
6. Place the pulp tank (6) so it fits in position on the left hand side of the
juicer’s main body.
7. Place the juice cup (7) under the Juicer spout.
8. Slide the food pusher (8) down the food chute. The pusher can only fit one
way.
IMPORTANT: If the Juice bowl and lid are not correctly assembled, the Juicer
will not operate. This is a safety feature.
USING YOUR JUICER
1. Clean fruit and vegetables thoroughly, ready for juicing.
2. If juicing fruit with stones or hard seeds, pit the fruit. Remove any hard
inedible skins, i.e. skin of melons, pineapples and man-
goes prior to juicing. If citrus fruits are being used,
remove the skin prior to juicing.
3. If pieces of fruit or vegetables are very large, chop
them to a size that will fit down the juicer’s food chute.
4. Ensure the safety clamps are locked in position on top
of the juicer lid.
5. Turn the control switch to ON to juice fruits.
6. Press the food pusher slowly down until all fruit or vegetables have gone
through the juicer. Do not press the food pusher rapidly
as the juicer will not be as effective.
7. CAUTION: do not put your hand or any other object in
the food chute during operation.
8. The juice from the fruit and/or vegetables will flow
directly into the juice cup and the pulp will be collected
in the pulp bin.
9. When juicing is complete, ensure that the juicer’s control switch is set to
the OFF position, the power is turned off at the outlet and the juicer is
unplugged. It is now safe to disassemble the unit.
10. If the Juice Bowl is stuck and does not detach from the base, Press
reverse button “R” 3-5 seconds. Repeat process 2-3 times. Then, push
bowl upward while turning.
11. The strainer equipped with auto-cleaning brush
with a dry towel. Do not immerse the supply cord or motor part of this appli-
ance in water or any other liquids.
This appliance has a built-in safety lock; this feature ensures that you can only
switch on the appliance if you have assembled the juicer correctly on the
motor unit. When assembled correctly, the built-in safety lock will be
unlocked.
ASSEMBLING THE JUICER
Before you assemble the juicer, ensure that the power cord is unplugged.
1. Place the Juice bowl (1) on top of the main body, make sure the juice bowl
in position so it locks into the main body and cannot be removed.
2. Put the strainer holder (2) into the juice bowl
3. Put the strainer (3) into the strainer holder