User's Manual

U
SER
’
S
M
ANUAL
Products are applied to hotel, supermarkets, offices, families, etc. Rate voltage:110V~120V.
Rate Frequency: 60HZ.
Caution:
The RF lighting device complies with part 18 of the FCC rules.
1. Use only on 110~120volt, 60Herz.
2. Never disassemble or modify, any changes could void the user’s authority to operate this
device.
3. Not for use in totally emergency exit fixtures or emergency exit lights.
4. Risk of electric shock-use in dry locations only.
5. This device is not intended for use with emergency exit fixtures or emergency exit lights.
6. This product could produce interference when used near a equipment or other critical
navigation or communication equipment operating between 0.45~30MHz. If interference
should occur, move the lamp away from the appliance a distance of three feet or more or
plug the lamp or the appliance into a different outlet.
7. To prevent burns do not touch the bulb during operation or immediately after switching
off.
8. Nor for use with dimmers, electronic timer or photocell devices or occupancy sensor.
9. Add weight of the device may cause instability of a freestanding portable.
10. Use only with portable table lamps in which the distance from the bottom of the base to
the top of the lamp holder does not exceed three times minimum base width.
11. Use only with portable table lamps which are provide with lap shades.
12. Use indoors with open, surface mounted and track fixtures.