Use and Care Manual

drainage pipe clip

screw

-27-

Installation of drainage hose

2. Remove the rubber plug at drainage port.

1. Fix the drainage pipe clip on the right of rear side plate near drainage port with

a screw.

3. Put the drainage pipe into drainage port and screw it up, and then bind it with

pipe hoop.

■

Instructions for drainage pipe installation.

1. In Cool, Dry or Heat mode operating, the condensation water will be drained to

■ Drainage way as follows.

the chassis.

2. When the chassis is full with water, the buzzer will give out 8 sounds and "H8" is

displayed to remind user to discharge water:

● Move the unit to a suitable place for discharging water;

do not tilt the unit and keep it horizontal during moving;

● Take the drainage pipe from the clip and pull out the

rubber plug on the drainage pipe to discharge water;

● After full water protection is eliminated and the compressor

has been stopped for 3 minutes, the unit will resume operation.

drainage port

pipe hoop

rubber plug

drainage pipe clip

drainage pipe