Use and Care Manual

-10-
1
2
4
3
5
Press this button to turn on the unit. Press this button again to turn off the unit.
Each time you press this button,a mode is selected in a sequence that goes from AUTO,
COOL, DRY, FAN,and HEAT
*
, as the following:
AUTO
COOL
DR
Y
FAN HEAT
*
*Note: Only for models with heating
function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
Press this button to decrease set temperature. Hold it down for above 2 seconds to
rapidly decrease set temperature. In AUTO mode, set temperature is not adjustable.
Press this button to increase set temperature. Hold it down for above 2 seconds to
rapidly increase set temperature. In AUTO mode, set temperature is not adjustable.
This button is used for setting fan speed in the sequence that goes from AUTO,
to
then back to Auto.
,
,
,
Auto
Low speed
Medium speed
High speed
6
If the unit is turned off during swing operation,the louver will stop at present position.
●
●
●
●
Press button to start or stop up & down swing function.The remote controller
defaults to simple swing condition.
(This function is not applicable for some models).
Press + button and button at the same time at unit OFF to switch between
simple swing and static swing; blinks for 2 seconds.
In static swing condition, pressing button, the swing angle of up & down louver
changes as below:
When setting HIGH fan speed unit will display TURBO fan speed.
ON/OFF :
MODE :
+ :
FAN :
:
- :
Operation of the remote controller
Remote controller description
This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.