User's Manual

12. Using Qi Wireless charging：
1. At standby mode, when you put your device on top of the unit under ‘Qi’, it can be charging wireless
2. At AUX, BT mode also can be charged Simultaneously
3. At FM mode, it can’t be charged with Qi
13. Using the USB charging port:
A 1 Amp USB port is located on the back of the unit for charging devices while the unit is connected to AC
power. Connect one end of a compatible USB cable into the standard USB port on the unit and the other end into the
device you wish to charge. Some devices require higher amperage USB charging ports. Monitor the charging status
of your device. If the device does not charge, you will need to use the charger that came with your device.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment shall be installed and operated with minimum distance 15cm between the radiator & body.