Instruction Manual

E6581279⑦
- 11 -
4. Connecting to the network
4.1. Installation method
(1) Using the DIP switchon the PROFIBUS option, seta station address. (Refer to Section
4.2.)
(2) Connect a PROFIBUS connector to the PDP002Z. (Refer to Section 2.1.)
* If the PDP002Z is located at an end of the bus, connect a terminal resistor to it.
(When using a connector with termination resistor, set it ON.)
(3) Once all the parameters are set, the power must be cycled to the VF-AS1/PS1 for
these changes to take effect. (Refer to Section 5.)
f)
ST
DX
MNS
MNS
MNS
LED name label