Operation Manual

38
Using the dynadock™ and Adjusting Settings
Using standby/sleep/hibernation modes with the dynadock™
❖ In Extended mode, windows that were previously on the
external monitor may appear on the computer's built-in display
when the computer resumes from standby/sleep/hibernation.
You may need to reposition the windows by dragging them to
the external desktop again.
❖ If the external monitor is in Extended mode and the computer
requires you to log in after resuming from standby/sleep/
hibernation, the login screen will appear on the primary
computer monitor, not the external monitor. This is consistent
with Windows
®
operating system standards.
Uninstalling the software
To remove the dynadock™ V software from your computer, please
follow the steps below.
Before uninstalling the software, do the following:
❖ Undock the computer from the docking station. See “Undocking
your computer” on page 26 for more information.
❖ Disconnect the dynadock™ from the computer by removing the
USB cable.
❖ Close all programs running on your computer.
1 Click Start, Programs or All programs, dynadock, and then
Uninstall dynadock.
2 Follow the on-screen directions to finish the uninstall.
NOTE