Operation Manual

34 35
Operations
Using the menus
You can call up on-screen menus, and conduct a number of adjustments and settings using
the MENU button
p.16
on the control panel (main unit side) and remote control.
Setup using the Setting display
The menu shown below is for operation instructions purposes and might differ from the
actual display.
These marks
signify that there
are options.
Press or
to display a list of
options.
* When no item is
changed, press .
These marks signify
that there are setting
screens. Press or
to display a list of
setting screens.
Toggle items with .
Select items with and press .
Fix selection with .
Display the Setting display menu.
1. Press the MENU button
2. Select a Category
3. Adjustments & Settings
• The figure shows displays given for operation instructions purposes. As the display may differ depending on the item,
refer to the following applicable pages for the menu item you desire.
• To return to previous item, press the RETURN button.
Item
Adjustment/Setting Value
These marks signify
the items can be
adjusted/set by using
.
These marks signify the items can
be selected from the list by using
.
After an item is selected, apply it by
pressing .
Press or to open the menu.
4. End Press the MENU button once more.
(The menu will disappear automatically after 30 seconds, if no operation is conducted.)
Select a category by using .
There are following 5 categories:
Displays the current
adjustments and
settings of selected
category.
Item shown with gray
cannot be adjusted with
the current input source.
p.35
Image adjustment menu
p.37
Display setting menu
Default setting 1 menu
p.40
Default setting 2 menu
p.41
Status display menu
p.42
■
The image adjustment menu
Use this menu to set or adjust image-related items. Items that can be set or adjusted
are marked “Yes”, and those that cannot are marked “No”. (When an item is masked, it
indicates that you cannot select for the current input.)
Item Description Computer Y/PB/PR Video S-video
Contrast
Adjust the image contrast.
Lower
Higher
Yes Yes Yes Yes
Brightness
Adjust the brightness of the image.
Darker
Brighter
Yes Yes Yes Yes
Color
Adjust the color of the image.
Lighter
Deeper
No Yes Yes Yes
Sharpness
Adjust the sharpness of the image.
Softer
Sharper
Yes Yes Yes Yes
Noise
reduction
*1
Set the function to reduce screen noise.
On (Enable) Off (Disable)
No Yes Yes Yes
Picture
mode
Press . Toggle the picture mode
with . 1/2/3
Yes Yes Yes Yes
R-level
Adjust red of the image color.
Less red
More red
Yes Yes Yes Yes
G-level
Adjust green of the image color.
Less green More green
Yes Yes Yes Yes
B-level
Adjust blue of the image color.
Less blue
More blue
Yes Yes Yes Yes
NTSC mode
*2
Set the black level with .
US : NTSC (US) mode
JAPAN : NTSC (JAPAN) mode
No No Yes Yes
Auto setting
Automatically adjusts items such as
the sampling phase depending on the
type of input signal.
Yes No No No
Position
Press then change mode using
and adjust with
Yes No No No
Phase
Adjust to eliminate flicker.
Yes No No No
Frequency
Adjust to eliminate periodic patterns
and flickering when many fine vertical
lines appear on the screen.
Yes No No No
H-position
Adjust the horizontal position of the
image.
Yes No No No
■