Operation Manual

Other functions

Remote control numbering function

By connecting multiple TD-Z421 and TD-Z471 monitors using RS-232C cables, you can control any one monitor or all the

monitors by one remote controller.

1 Assign arbitrary ID number to each of multi-connected TD-Z421 and TD-Z471 monitors using MONITOR ID. ID

numbers 1 to 26 are selectable. It is recommended to assign sequential ID numbers from 1 and up.

2 The remote control mode of the rst TD-Z421/TD-Z471 monitor is set to PRIMARY and those of the other monitors are

set to SECONDARY.

3 When you direct the remote controller at the remote control signal sensor of the PRIMARY monitor and press the

DISPLAY button on the remote controller, the ID selection OSD appears at the upper left of the screen.

ID number of the currently viewed monitor

Select the ID number of the monitor you want to control using the +/- button on

the remote controller. The ID of the monitor you want to control is displayed

at the upper left of its screen. By selecting ALL, you can control all the multi-

connected monitors.

4 Direct the remote controller at the remote control signal sensor of the PRIMARY monitor. OSD appears on the

monitor having the ID number you selected.

When the ID selection OSD is being displayed on the PRIMARY monitor, press the DISPLAY button on the remote

controller again to cancel the ID selection OSD and then control the monitor you selected.If you set the remote control

mode wrongly and remote control operation becomes unavailable, press any button on the control panel of the monitor to

display the OSD screen and change the remote control mode using ADVANCED OPTION. By pressing and holding down

the DISPLAY button on the remote control for 5 seconds or longer, the remote control mode is initialized to NORMAL.

Remote control numbering function