Operation Manual

50
How to Use
Mode Description
COLOR
[COLOR]:You can adjust all the colors at the same time. Press the PLUS (+) button to
deepen the colors. Press the MINUS (-) button to lighten the colors.[RED], [MAGENTA],
[BLUE], [CYAN], [GREEN], or [YELLOW]:You can adjust each color individually. Press
the PLUS (+) button to deepen the selected color. Press the MINUS (-) button to lighten the
selected color.
This adjustment doesn’t work in the sRGB picture mode.
COLOR
TEMPERATURE
You can adjust the color temperature.The image becomes reddish as the color temperature
decreases, and it becomes bluish as the color temperature increases.
This adjustment doesn’t work in the sRGB picture mode.
COLOR CONTROL
The color levels of red, green, and blue are adjusted by the color bars.
R: Red, G: Green, B: Blue
This adjustment doesn’t work in the sRGB picture mode.
GAMMA SELECTION
You can select the gamma mode from NATIVE, S GAMMA, 2.2, 2.4, OPTION, and
PROGRAMMABLE.PROGRAMMABLE can change the GAMMA characteristic curve
via a computer.Contact your dealer for further details.
GAMMA is f xed to 2.2 in the sRGB picture mode. When PROGRAMMABLE has been
selected, the setting for color temperature i s f xed at 10,000 K (NATIVE).
AUTO BRIGHTNESS
This function controls the screen brightness depending on the ambient light for easy
viewing.In addition, it changes the screen brightness depending on the ambient light and
what are displayed on the screen to reduce power consumption as low as possible.
This adjustment doesn’t work in the sRGB or CINEMA picture mode.
[AUTO BRIGHTNESS]
AUTO:
The settings of AUTO BRIGHTNESS are adjusted automatically.
When you sele ct AUTO, you cannot adjust any other items than
[CONTROL] individually.
LOCAL:
The AUTO BRIGHTNESS function is enabled and you can adjust
[CONTROL] and subsequent items individually.
REMOTE:
The AUTO BRIGHTNESS function is enabled. In addition, the monitor
enters the intercommunication mode where multiple monitors are
controlled collectively. (See page 65.)
OFF: This function is disabled.
[CONTROL]
PRIMARY:
Select this setting to conf gure the monitor as Master when controlling
multiple monitors collectively.
SECONDARY:
Select this setting to use the monitor alone or to conf gure the monitor as
Slave when controlling multiple monitors collectively.
[LIGHT FROM BACK]
This function is enabled only when [REAR SENSOR] is ON.When a light source such as a
light and a window is behind the monitor, the rear sensor takes precedence.
YES:
Select this setting when there is a light source such lighting equipment and
a window behind the monitor.
NO:
Select this setting when there is no light source such lighting equipment
and a window behind the monitor.
[BACK WALL]
This function is enabled only when [REAR SENSOR] is ON.Select the following settings
according to the distance between the rear of the monitor and the wall or window.
FAR: The distance is 5 meters or longer.
NEAR: The distance is 5 meters or shorter.
[FRONT SENSOR]
Select ON for normal use.
OFF: Select this setting when the sensor on the front panel is shielded.
Picture