Operation Manual

16
Preparation for use
Using the wall mount or ceiling mount
Lay the screen face down
Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen
surface so as not to scratch the screen surface.
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure to follow the
correct mounting procedures can result in damage to the equipment or injury to the user or installer. Product warranty does
not cover damage caused by improper installation. Failure to follow these recommendations can void your warranty.
For installation, use M6 screws (with a loose-proof spring washer and having a length 10 mm longer than the thickness of
the mounting bracket) and tighten them securely.
Toshiba recommends using a mounting interface that complies with VESA Requirements, TUV-GS or for North America
UL1678.
42” 47”
485 485
200 200
200 200
281.45281.45
Handles
Protective Sheet
(mm)
Table
400.00
200 200
540.1 540.1
200200
312.2312.2
Handles
Protective Sheet
(mm)
Table
For preventing the monitor from falling:
• Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your own
responsibility. For detailed procedures of installation, refer to the instructions of the metal brackets.
• To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for installation location.
• To lessen the risk of falling of the monitor, thread commercially available rope through the handles at the right and
left of the monitor and secure the rope to the wall mount brackets or ceiling mount brackets. Use rope that can bear a
load 6 times the weight of the monitor (42” approximately 90 kg; 47” approximately 102 kg ).
• Do not sleep where the monitor may topple over or fall in case of an earthquake or other disaster.
• Use screws having enough strength to support the LCD display monitor (made of stainless steel etc.).
About the metal bracket:
• Use a VESA-compliant metal bracket.
• Before installation, make sure that the installation surface has sufficient strength.
• Use a metal bracket (commercially available) that is strong enough to hold the monitor.
• Before installation, check the strength and other properties to ensure the safety.
• Do not block the heat dissipating holes in the monitor with the metal bracket. See page 15.
• For details of the mounting procedure and the safe installation procedure, see the user instructions of the metal
bracket (commercially available) to be used.
• Take measures such as using multiple metal brackets, holding the monitor at several points, and taking measures to
prevent falling or dropping in case of a problem.
Using the wall mount or ceiling mount