Manual

ttl g the video channel
When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be set to
channel 3 or 4 (video channel).
Press and hold 3 or 4 on the remote for 3
seconds in standby mode.
The video channel will
C'_b OR _'b start to flash for 3
_ seconds in the display
window,
\ /
/ \
Press POWER to turn on the DVDNCR.
3
Press VCR DVD selector to select the VCR mode.
VCR
DVD The VCR indicator on the
O front panel will light,
_d;3
Turn ON the TV and set to CH 3 or 4 to corre-
spond with the channel selected in step t.
Press TV/VCR to select the VCR position.
TVNCR The VCR indicator will
O appear in the display
window.
Select any channel to receive a TV station in your area,
The channel number will appear on the screen for
about 4 seconds.
• For a push*button TV tuner
If CH 3 or 4 corresponding to the video channel cannot
be tuned on your TV, proceed as follows: set the VCR
3/4 channel selector and the TV to CH 3 or 4, play
back a prerecorded tape and tune the TV to receive a
sharp color picture from the video cassette recorder.
Refer to your TV owner's manual for details.
Notes:
• If the unit does not operate properly, or No key operation
(by the unit and/or the remote control): Static electricity,
eta., may affect the player's operation. Disconnect the AC
power cord once, then connect it again.
• Dudng the DVD playback if you change the operating mode
from DVD to VCR, the DVD will continue to play back the disc
and stop after about 5 minutes.
122