User Guide

Error Messages
Scale View V4.0 Owner’s Manual
Page 32 18-Oct-04
“Run Time error 76”
when trying to access
TMCC log
The file “notepad.exe” is not found in the default
directory. The default directory for Scale View for
“notepad.exe” is “C:\Windows”. This error usually
occurs with Windows NT, Windows NT WS and
Windows NT 2000.
To correct this first confirm that there is not a
“Windows” subdirectory. If there is no “Windows”
subdirectory you must create one and copy the file
“notepad.exe” into it. This should take care of this
error.
An error occurs when
requesting a report
“Unable to connect, incorrect session parameters.”
Or Microsoft Access opens and requests a
password.
These problems occur because of a conflict between
different versions of Crystal Reports installed by
other programs.
Contact your TEC Representative for assistance.
Scale Not
Communicating
In Scale View V4.0 this error indicates that there is a
problem with a Scale’s IP address. This problem
could be that it isn’t programmed in the scale or in
Scale View’s Scale Table correctly. Check the Scale
View Scale Table configuration and the Scale’s IP
address.