User Guide

TOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION
TOP COVER REMOVAL COOLING MODULE REMOVAL
1. Disconnect the fan cable from PJ770 on the top
board.
2. Remove four M2x4 brass screws and two M2.5x6
black screws securing the cooling module.
3. Lift out the cooling module.
CPU REMOVAL
1. Insert a flat head screwdriver in the CPU lock and
rotate it counter-clockwise to unlock the CPU.
2. Lift out the CPU.
RTC BATTERY REMOVAL
1. Disconnect the RTC harness from PJ5 on the
Battery/LED board.
2. Lift out the RTC battery.
NOTE: When installing the CPU, make sure that a silicone
grease is applied before attaching the heat sink.
Please refer to FSB-200112 for the complete
procedures on how to apply the silicone grease.
Satellite
TM
LCD/FL harness
Left
speaker
cable
Right
speaker
cable
PJ310
PJ311
PJ34
3. Disconnect the left speaker cable from PJ310 and the
right speaker cable from PJ311 on the top board.
4. Disconnect the LCD/FL harness from PJ34 and the IPS
membrane switch fromPJ309 on the system board.
5. Remove one M2.5x6 black screw securing the top cover.
6. Lift out the top cover assembly.
PJ770
Cooling
module
M2X4 brass screws
Fan
cable
CPU lock
Silicone grease
CPU
Open
Close
RTC Battery
RTC harness
PJ5
M2.5x6
black screw
M2.5x6
black
screws
TE2000
Download service manual and resetter printer at http://printer1.blogspot.com